Item No.: B03AL613

.Deliver up to 1200 hammer blows per minute with the pull

.Compares to a 3.5 to 4.5 lb. manual slide hammer on hard joints (rusted, solid and stuck parts) and 4.5 to 6 lb. on non-hard joints (dent pulling, rear axle bearings, etc.)

.Common 5/8 in.-18 threads for use on the majority of slide hammer attachments to pull everything from pilot bearings to hubs and collision repair

.Both the extension rod and spindle threads match for use with either more reach or as a stubby slide hammer, working where traditional tools do not have enough clearance

.Lever throttle allows for adjustment of force and speed,allowing you to stay focused on the workpiece and dial inthe required power while the tool does the work.Power scales with inlet pressure and volume, 90-120 psi recommended