Item No.: B01AI097

.Tool for disassembly or assembly of particularly fixed injectors.

.For easy removal and fitting of seized  injectors.

.Comes complete with a  universal adaptor set that cover

 Bosch,Delphi,Denso, Siemens CRinjectors which has solenoid

 coil or screw connections.

.Covers 99% of injectors.

.Step1:elect the correct connector according to the injector

.Place the Puller between the connector and injector, and tighten it.The torque of the wrench is between 20-30Nm.

.WARNING: If loose it may cause damage during the impact drawing process.Please make sure it is torqued correctly.

.Step2:Use high pressure bar [the working air pressure isgenerally between 8-11 bar].  Adjusting the switches at bothends to the left to pull out the injectors.Adjusting theswitches at both ends to the right to install the injectors.

.WARNING: If the air is not clean and free of moisture itwill cause the internal cylinder of the puller to be stuckor corroded.

.Step3:When the injector is about to be pulled out or fittedalmostly, switch off or reduce the air pressure in order toprevent the  injector head from hitting the engine's waterbonnet or other parts.

.Step4:When the process is complete, store the Vibration MateIf in its box in a dry place.Regularly inject about 1ml of ail into the air inlet of thepuller every 10 hours of work to prevent the internal piston cylinder  from becoming wet and causing rust.